36
Template Go, Version 1, 01.07.2014 / ModuleVersion 1.0
Using the handset as an alarm clock
Gigaset E560A / LUG GBR en / A31008-M2708-L101-1-7619 / applications_LUG.fm / 7/14/16
Using the handset as an alarm clock
Activating/deactivating the alarm clock
¤ Menu Alarm clock OK Activation OK (=on)
After you activate the alarm clock, the menu for setting the wakeup time opens automatically.
Setting the wakeup time
¤ Menu Alarm clock OK Wake-up Time
OK Enter wakeup time OK
If the alarm clock is activated, you will see the icon in the
display and the wakeup time after it.
Setting the alarm clock signal
¤ Menu Alarm clock OK Signal OK (=on)
Switching off/repeating the alarm after an interval (snooze mode)
Prerequisite: An alarm call sounds.
¤ Deactivate until the next alarm call: Press Off.
Or:
¤ Snooze mode:
Press Snooze or any key. The wake-up call is deactivated and then repeated after 5 minutes.
Or:
Press nothing. The alarm call is deactivated after 60 seconds and then repeated after
5 minutes. After the fourth repetition, the alarm call is deactivated for 24 hours.
• When using Eco Mode+ you can ensure that the range of the base is sufficient by
long pressing the talk key . You hear the dial tone if the base can be reached.
• When Eco Mode+ is enabled:
• Call setup is delayed by approx. 2 seconds.
• Handset standby time is reduced by approx. 50%.
• Registering handsets that do not support Eco Mode+ causes the mode to be deac-
tivated on the base and all other handsets.
• Activating Eco Mode reduces the range of the base.
• Eco Mode / Eco Mode+ and repeater support ( p. 46) cancel each other out i.e.,
if you use a repeater you cannot use Eco Mode or Eco Mode+.
The time is set
( p. 10).
The wakeup time is shown in the display only when all
calls in the call lists have been listened to or read.
To Next Page
