46
Template Go, Version 1, 01.07.2014 / ModuleVersion 1.0
Base settings
Gigaset E560A / LUG GBR en / A31008-M2708-L101-1-7619 / settings_BS.fm / 7/14/16
Base settings
The base settings are made using a registered handset.
Activating/deactivating music on hold
¤ Menu Settings OK Telephony OK Music on Hold OK (=on)
Activating repeater support
You can increase the range and signal strength of the base using a repeater. You will need to acti-
vate repeater mode. This will terminate any calls being made via the base at the time.
Prerequisite: A repeater is registered.
¤ Menu Settings OK System OK Repeater Mode
OK ( = activated)
After activating or deactivating the repeater, switch your handset off and on again
(
p. 11).
Protecting against unauthorised access
Protect the system settings of the base with a system PIN known only to yourself. You will need
to enter the system PIN when, for example, registering/de-registering a handset to/from the
base.
Changing the system PIN
You can change the base's 4-digit default system PIN ("0000") to a 4-digit PIN known only to
yourself.
Changing the system PIN enables remote operation of the answer machine p. 31.
¤ Menu Settings OK System OK System PIN OK System
PIN: (enter the current system PIN) OK New PIN: (enter your new system PIN) OK
Resetting the system PIN
If you have forgotten your system PIN, you can reset the base to the original code 0000:
Disconnect the power cable from the base. Hold down the registration/paging key on the base
while reconnecting the power cable to the base. Hold down the key for at least 5 seconds.
The base has now been reset and the system PIN set to 0000.
• Eco Mode / Eco Mode+ ( p. 35) and repeater support cancel each other out i.e.,
if you use a repeater, you cannot use Eco Mode or Eco Mode+.
• The default encrypted transmission setting is deactivated when repeater mode is
activated.
To Next Page
Loading...
