51
Gigaset E560A / LUG GBR en / A31008-M2708-L101-1-7619 / appendix_legal.fm / 7/14/16
Template Go, Version 1, 01.07.2014 / ModuleVersion 1.0
Service (Customer Care)
You hear a tone during the call
• The batteries are empty Charge the batteries ( p. 9)
Forgotten system PIN
• Reset the system PIN to 0000 ( p. 46)
Error tone sounds after system PIN prompt
• The system PIN you have entered is incorrect Re-enter the system PIN or reset ( p. 46)
The device has come into contact with liquid
• Allow the device to dry. Contact with liquid ( p. 53)
The emergency function could not be configured
• You have not saved any emergency numbers Save at least one emergency number ( p. 25)
• The emergency function is not activated Activate the emergency function ( p. 25)
• The emergency function only works when the device is directly connected to the network or to a PABX
that does not require "R" or "P" for network assignment Emergency function direct dial key ( p. 24)
The receiver of an emergency call does not pick up
• In some PABX, acceptance of the emergency call by pressing the key 5 does not divert this to the
connected handset. The emergency function is not possible in this case, as a conversation cannot be held.
Test the emergency function after set-up with each receiver entered.
Exclusion of liability
Your handset's display consists of pixels. Each pixel consists of three sub-pixels (red, green, blue).
It may be the case that a sub-pixel is missing or has a colour deviation.
A warranty claim is only valid if the maximum number of permitted pixel errors is exceeded.
Description Maximum number of permitted pixel errors
Colour illuminated sub-pixels 1
Dark sub-pixels 1
Total number of coloured and dark sub-pixels 1
Signs of wear on the display and casing are excluded from the warranty.
To Next Page
Loading...
