GigE MotionBLITZ EoSens mini1 - Page 51

SyncOutSelect
This feature defines the camera signal to connect to the Sync Out / ARM pin of
the camera connector.
Access Read / write
Interface IEnum
Unit --
Range ARM, SyncOut
Invalidation --
Precondition CameraState = Idle
Note ARM = Signals that the camera is in circular recording
mode.
SyncOut = If set, the camera outputs a strobe signal
which is equivalent to the exposure time of the cam-
era.
SyncARMPolarity
This feature defines the polarity of the ARM signal.
Access Read / write
Interface lEnum
Unit --
Range positive, negative
Invalidation --
Precondition CameraState = Idle
SyncInPolarity
This feature defines whether the camera is synchronized to the falling or rais-
ing edge of the sync in signal.
Access Read / write
Interface IEnum
Unit --
Range rising, falling
Invalidation --
Precondition CameraState = Idle
Feature description
MikrotronGmbH / mini1 / CAMMC1370/71-RG / 2021 51 - 67