GigE MotionBLITZ EoSens mini1 - 3.14 Multiple slope

3.13.2 Controls
ExtTriggerPolarity
This feature defines if the camera trigger gets active on the rising or falling
edge of the external trigger signal.
Access Read / write
Interface IEnum
Unit --
Range Rising, Falling
Invalidation --
Precondition CameraState = Idle
ExtTriggerEnable
This feature enables or disables the input port for an external trigger signal.
Access Read / write
Interface IBoolean
Unit --
Range True, False
Invalidation --
Precondition CameraState = Idle
3.14 Multiple slope
3.14.1 Overview
The Multi Slope feature of the camera can be used to increase the dynamic
range of images taken by the camera. At a user defined time within the expos-
ure time, all pixel that exceeds a predefined value of luminosity gets its lumin-
osity reset to this value. Pixels that are smaller than this value remain
untouched. The rest of the exposure time all pixels gets exposed as usual.
The effect of this algorithm is that normally over exposed pixels are reduced in
luminosity while darker pixels keep their value. The result is an exposure with
an increased dynamic range. mini1 cameras can set one or two different
Feature description
MikrotronGmbH / mini1 / CAMMC1370/71-RG / 2021 53 - 67