GigE MotionBLITZ EoSens mini1 - Recordstandby (Usersets)

RecordMode = Single
RecordNumberOfSequences = One and unavailable (automatically)
RecordWhileTriggerActive = True
RecordBurstCnt = 0
RecordStart
...
recording as long as trigger active
wait
...
recording as long as trigger active
...
recording stops automatically (CameraState = IDLE), then
RecordStop
Read the number of recorded frames form the feature RecordNum-
berOfFrames which should be equal to RecordNum-
berOfFramesPerSequence.
The programming flow for the Burst mode is:
RecordMode = Single
RecordNumberOfSequences = One and unavailable (automatically)
RecordWhileTriggerActive = False
RecordBurstCnt = x(unequal to 0 )
RecordStart
...
recording after one trigger x frames
...
wait
...
recording after one trigger x frames
...
recording stop automatically (CameraState = IDLE), then
RecordStop
AcquisitionStop
Read the number of recorded frames form the feature RecordNum-
berOfFrames which should be equal to RecordNum-
berOfFramesPerSequence.
4.3.5 RecordStandby (UserSets)
This mode is used to keep the images of a previously recorded sequence in
the camera memory.
n The feature RecordStandby must be activated before a new recording is
started.
n Most parameters describing the recorded sequence will be stored in non-
volatile memory except the values for frame Width, Height, OffsetX and
OffsetY. These values must be saved separately by setting the UserSets
feature to UserSet1 and saving the frame size in the camera by sending
the command UserSetSave.
The frame size of the images in the camera buffer must be saved to User-
Set1 because a number of record parameters will be calculated in
Programming
MikrotronGmbH / mini1 / CAMMC1370/71-RG / 2021 63 - 67