Disc screws torque 6 ÷ 6,5 N•m Wheel axle nut torque 100 ÷ 125 N•m
Front brake disc
Removal
- Remove the front wheel loosening the axle
clamp.
- Unscrew five disk clamps.
Refitting
- On refitting, position the disc correctly, making sure to turn it in the right direction and apply medium
threadblock.
Recommended products
Loctite 242 product description
Apply LOCTITE medium type 242 threadlock
Locking torques (N*m)
Disc tightening screw 6 ÷ 7 N•m
Disc Inspection
-Remove the wheel and check any out of level of
the disc using the specific tool.
-The measurement revealed must be within 0.1
mm. If the measurement, is greater replace the
disc and repeat the test.
- If the problem continues check and if necessary
replace the wheel rim.
Specific tooling
020335Y Magnetic support for dial gauge
Front brake pads
Runner Purejet Braking system
BRAK SYS - 5
To Next Page