Replacement
- Remove the oil charging cap.
- Unscrew the oil drain plug "B" and allow the oil to flow out completely.
- Rescrew the drain plug "B" and refill the engine with oil until it touches the full hole (apporx. 75cc.).
- The level must correspond to the second notch starting from the bottom as shown in the picture.
WARNING
DO NOT REMOVE THE OIL PLUG STRAIGHT
AFTER AN ACTIVITY WITH THE ENGINE AT
FULL SPEED AND /OR WITH THE ENGINE
RUNNING.THE OVERHEATED OIL COULD
LEAK WITH DANGER OF BURNS
Recommended products
AGIP ROTRA 80W-90 Rear hub oil
SAE 80W/90 Oil that exceeds the requirements of
API GL3 specifications
Air filter
Removal
- Remove the 6 screws shown in the picture.
Cleaning
- Wash with soap and water.
- Dry.
Maintenance Runner Purejet
MAIN - 6
To Next Page
Loading...
