Cooling system
Level check
- Remove the front grille
- Check that the coolant level is between the min
and max reference marks.
Top up with recommended coolant, if necessary.
Recommended products
AGIP PERMANENT PLUS Coolant
Monoethylene glycol antifreeze fluid, CUNA NC
956-16
See also
Legshield
Headlight adjustment
Place the vehicle with the driver on level ground
10 m from a white screen in the shadows (see side
picture) and ensure the vehicle axle is perpendic-
ular to the screen.
Trace a horizontal line on the screen with a ground
height of 65 ÷ 67 cm; start the engine and block
the gas knob so the vehicle stays still, switch on
the headlight, engage the lower beam and direct it
so the horizontal demarkation line between the
area in shadow and lit up area does not go above
the horizontal line traced on the screen.
To access the adjusting screw of the headlight re-
move the front cowling. Loosen the screw with star
notch. Before directing the headlight check the
tires are inflated to the correct pressure.
Runner Purejet Maintenance
MAIN - 9
To Next Page
Loading...
