- DURING THE OPERATIONS, THE VEHICLE
MUST BE ON THE STAND AND LEVEL.
N.B.
DURING PURGING FREQUENTLY CHECK THE
LEVEL TO PREVENT AIR GETTING INTO THE
SYSTEM THROUGH THE PUMP.
WARNING
- BRAKING CIRCUIT FLUID IS HYGROSCOPIC.
IT ABSORBS HUMIDITY FROM THE SUR-
ROUNDING AIR.
IF THE LEVEL OF HUMIDITY IN THE BRAKING
FLUID EXCEEDS A GIVEN VALUE, BRAKING
EFFICIENCY WILL BE REDUCED.
THEREFORE, ALWAYS USE FLUID FROM
SEALED CONTAINERS.
UNDER NORMAL DRIVING AND CLIMATIC
CONDITIONS YOU SHOULD CHANGE THIS
LIQUID EVERY TWO YEARS.
IF THE BRAKES ARE USED INTENSELY AND/
OR IN HARSH CONDITIONS, CHANGE THE
FLUID MORE FREQUENTLY.
CAUTION
WHEN CARRYING OUT THE OPERATION,
BRAKE FLUID MAY LEAK FROM BETWEEN
THE BLEED SCREW AND ITS SEAT ON THE
CALLIPER.
CAREFULLY DRY THE CALLIPER AND DE-
GREASE THE DISC SHOULD THERE BE OIL
ON IT.
Specific tooling
020329Y MityVac vacuum-operated pump
Recommended products
AGIP BRAKE 4 Brake fluid
FMVSS DOT4 Synthetic fluid
Locking torques (N*m)
Oil bleed screw 8÷12
Front brake pump
- After removing the front and rear handlebar cover, loosen the two clamps on the kickstand (see pic-
ture).
- Disconnect the tube, collecting the brake oil in a container.
Runner Purejet Braking system
BRAK SYS - 7
To Next Page