8
InstallationModel: GHM Warmer Series
Unit is shipped on a wooden skid with a protective wooden framework; secured to the skid by means of high strength
strapping. The entire skid is wrapped with machine-applied stretch wrap. Auxillary items, such as Side Glasses, Pan
Dividers, Legs and Fluorescent Lights, are packed separately, contained in cartons packed in the pan well. Be certain
to remove and retain.
•
Appliance is heavy ... Exercise care when lifting or moving ... Use adequate manpower or appropriate handling
equipment.
• Exercise care when removing and disposing of the wooden crate material.
• Failure to comply with CAUTION notices may result in minor to moderate injury, equipment or property damage,
and could void the factory warranty.
IMPORTANT!
If the crate shows evidence of damage, immediately inspect the entire unit and the accessory items. Notify the
freight company of any and all damages observed. Typically, it will be the purchaser’s responsibility to negotiate
freight damage claims with carriers.
1. Carefully cut and remove plastic wrap and strapping, then use appropriate tools to remove wooden crate
framework from the pallet.
2. Remove items packed in the pan well, examine for damage and set aside.
3. Carefully remove the unit from the shipping pallet. Units are extremely heavy, see Section 1.04.4, Weights. Use
appropriate lifting equipment, or adequate manpower. Due care should be taken when lifting and moving the unit
to prevent personal injury or equipment damage. Giles shall not be liable for personal injury or damage caused by
improper handling, or use of poor work practices.
1. For free-standing, counter-top applications, four (4) Adjustable Legs are supplied ... two (2) Regular and two (2)
Floor Plate.
2. Install and secure the Adjustable Legs at each corner. Each style Leg should be installed on the opposite diagonal
corners from one another. Take care to not cross-thread studs.
3. Place unit onto a suitable counter-top that is substantial enough to safely support the appliance.
4. Level unit by rotating the lower portion of the Legs to adjust the length as needed ... clockwise shortens leg,
counter-clockwise lengthens legs. Unit should be stable and level; side-to-side, front-to-back and corner-to-corner.
Regular Leg Floor Plate Leg
2.02 Unpacking
2.03 Counter-Top Installation
To Next Page
Loading...
