25
Operation Model: GHM Warmer Series
4. Install Pans into the various spaces created by the grid of Support Channels. The above represent typical
arrangements, but there are many different pan layouts that can be devised. Enough Pan Dividers are provided
with the unit to set-up Configuration #2. Additional dividers can be purchased separately.
NOTE:
Ensure there are NO gaps between Pans. Spaces can result in heat lose.
5. Close the Front Curved Glass and/or Rear Sliding Doors.
4.01 Pan Installation - continued
Pans to be supplied by Customer; NOT provided with Warmer. Unit will accept standard steam table pans of
various sizes with pan depth of 2-1/2” to 4” [63.5 mm to 101.6 mm].
To Next Page
Loading...
