18
Issue: 8 (Applies to firmware 2387 6.09 onwards)
Document number: 1390-PS-0039
Pipe mounting (use with Pipe Mount)
The Pipe Mount base for the WindObserver 65 has the following dimensions.
Included in the supplied mounting kit is an O Ring Seal which must be fitted inside of the Pipe Mount Base.
The mounting pole dimension should be 50mm (1.97”) diameter.
Three M5 x 12 hex screws are provided to secure the Pipe Mount to the WindObserver base.
Three M5 x 12 hex screws to secure the Pipe Mount to the pipe through M5 tapped holes in the Pipe Mount.
If a screw threaded pole is used it should be a 1.5-inch National Pipe Thread (NPT) type.
It is recommended that the WindObserver mounting pole be manufactured from Stainless Steel 316, to prevent possible
galvanic corrosion.
To Next Page
Loading...
