19
Issue: 8 (Applies to firmware 2387 6.09 onwards)
Document number: 1390-PS-0039
base has three M5
tapped holes, 8mm
deep.
Custom Mount (Use with WindObserver No Mount Option)
Although it is recommended that customers select a base mount option from Gill Instruments, should a customer wish
to design their own mount then the WindObserver base dimension details for this are as follows:-
Updated Cable Gland Base Assembly
All models that utilise the cable gland fitment will now have an updated base assembly which will allow for either a direct
panel mount attachment (as per the WindObserver 2) or use of the panel/pipe mount adaptors (as per the WindObserver
65/70/75/90):
Figure 2;
updated base fitment for cable gland model variants
56.60mm
To Next Page
Loading...
