2.2 Basic operation of G10
In this section, we highlight the basic operation of G10. It includes powering on/off,
checking work station, changing work mode, register receiver, download static data,
WEB UI function, self-checking, firmware upgrading. All of these basic operations are
simple and easy. But they are very important
2.2.1 Power on/off
This is the first step to use G10, it’s very easy to operate. When the receiver has
battery, keep press power key for some seconds, then you will see the LOGO of GINTEC.
If you want to power off the receiver, keep press power key again, when it’s in the
state of power-on.
2.2.2 Self-checking
If the indicators are abnormal or the receiver can’t work normally, for example the
Bluetooth can’t be connected, the radio mode can’t work, it can’t connect to the CORS.
Then you can use the automatic detection function, which is mainframe self-checking.
Self-checking will check radio mode, GSM mode, Bluetooth mode and. During this
procession, it has voice guide tell you whether it’s normal or not.
Power on, press and hold power button about 8 seconds until it powers on again
with voice guide from the receiver. Then release the button to hear the result.
To Next Page
Loading...
