USER MANUAL
Range BEAT-Tr
Edition: January 2016
- MAINTENANCE Revision: No. 3 48
5. Once the downloading process is completed, the unit will automatically initiate an
starting up cycle where the new software version can be checked.
NOTE
: Upgrading the software version the language if shifted into English and the
fusion data, fusion counter, operator and job data will be erased.
6. Switch off the unit and unplug the transmission cable.
WITH PENDRIVE USB/A (FOR MODELS WITH USB CONNECTOR ONLY):
Recognition of downloading file:
1. With the unit switched on, connect a memory stick in the USB/A connector. The
unit detects the presence of the file and generates an internal flag to start the
update process. Therefore, the stick:
C Must contain the file / Beat / BTR_xxxx.bin for the version you want to
load, which must be in the directory Beat.
NOTE
: where xxxx is the version of software between 000 and 999; if
there is more than one file BTR_xxxx.bin, the highest version will
be loaded.
C Must be FAT or FAT32 format and single partition.
Downloading process
:
1. Turn off the unit (at least 5 seconds after having detected the file), press the ©
key and put it back up through the master switch. The downloading process starts
automatically. You must wait for the process to finish the drive clean and autoreset
characteristic.
2. Once the downloading is complete, the unit automatically starts showing start-up
screen, in which we can verify the correct loading of the software version made.
NOTES
: C When you upgrade the software with a new version, language
becomes the default English, and the fusion data, fusion counter,
operator and job data will be erased.
C To operate the scanner, the unit must be restarted after
downloading.
3. Turn off the unit and remove the pendrive.
To Next Page
Loading...
