USER MANUAL
Range BEAT-Tr
Edition: January 2016
- INTRODUCTION Revision: No. 3 6
1.2 DESIGN SPECIFICATIONS
The electrofusion units BEAT-Tr and MINI BEAT-Tr are designed according to the
following specifications:
C ISO 12176-2 Equipment for fusion jointing polyethylene systems.
Part 2: Electrofusion.
C ISO 12176-3 Equipment for fusion jointing polyethylene systems.
Part 3: Operator's badge.
C ISO 12176-4 Equipment for fusion jointing polyethylene systems.
Part 4: Traceability coding.
C ISO/TR 13950 Plastic pipes and fittings: automatic recognition of
electrofusion systems.
Both electrofusion units accept all the identifications which correspond to the above listed
Specifications. All the fittings can be fused by electrofusion if the manufacturer encloses
the programmed bar code system in accordance with ISO/TR 13950.
1.3 GENERAL INFORMATION
The development, documentation, production, tests and shipping of the products herewith
described have been made:
M Complying with the respective safety rules, and
M In accordance with the requirements of quality guarantee.
WARNING !
The electrofusion control box can only be opened by the STPAcuster
group After-sales Service. In the case of the back cover opening or
coming apart, parts of electrical components which are not covered may
be left exposed.
Only qualified personnel are authorised to intervene both for fusion and
repairs. These qualified personnel must be familiar with all the safety
measures, potential dangers and maintenance rules described in this
Manual.
The safe use of the products described requires an appropriate means of
transport, storage, installation and use, a careful handling and the
preestablished periodical maintenance follow-up.
To Next Page
Loading...
