USER MANUAL
Range BEAT-Tr
Edition: January 2016
Revision: No. 3 INTRODUCTION - 9
M The fusion control boxes which are not being used must be kept out of the reach
of the non authorised personnel. They will have to be kept in rooms of low
humidity degrees and of restricted access.
M Always use adequate working clothes.
For outside work, it is recommended to use rubber gloves and boots with
insulating soles (in wet areas, this advice is essential), and other applicable
personal protective equipment such as hard hat, safety glasses, etc.
For indoor fusion jointing work, adequate ventilation of the premises must be
provided.
M Before using the fusion control box, its external condition will have to be checked,
as well as its working condition. All components must be correctly assembled in
order to guarantee the correct functioning of the unit.
M The damaged components must be repaired or replaced by the After-Sales Service
of STPAcuster group.
M The fusion control box can only be opened by the After-Sales Service of
STPAcuster group.
M Should the fusion control box not work properly, it will have to be sent
immediately to the After-Sales Service of STPAcuster group.
To Next Page
Loading...
