GLOBALJIG INTERNATIONAL S.r.l.
25
7. MAINTENANCE INTERVENTIONS
7.1. Introductory notes
This chapter addresses topics regarding routine and/or special maintenance interventions.
Any operators authorized to perform the activities illustrated below must be in possession of Qualification 1.
Each intervention requires the presence of a single qualified operator, who must perform the interventions with
the LP’s electrical and pneumatic power supplies shut off.
Routine maintenance interventions are intended as those which are scheduled by the manufacturer, while
special maintenance interventions are intended as those which are not scheduled.
Any interventions not foreseen within this manual which could have considerable consequences on the
functionality of the LP must be preventively agreed with the GLOBALJIG Customer Assistance Service. This is
to avoid any malfunctions or breakdowns following the repairs, which are difficult to anticipate by those with
complete knowledge of the LP’s design principles.
7.2. Customer Assistance Service
The KOALA LP is covered by warranty for a period of 12 months. The warranty period begins upon the
shipping or delivery date.
Technical assistance is guaranteed by the manufacturer (or at the local reseller), with intervention times limited
to 48 hours (excluding holidays) from the time of the call.
In order to contact the GLOBALJIG Customer Assistance Service, call or send a fax to the following numbers:
Telephone: 0585-8364
Fax: 0585-833880
7.3. Routine maintenance
The routine maintenance interventions foreseen by the manufacturer for the KOALA LP are listed in the
following table. The personnel authorized to perform these interventions must be in possession of Qualification
1.
INTERVAL INTERVENTION DESCRIPTION SECTION
8 hours LP Cleaning 7.3.1
160 hours Check the efficiency of the safety pin 7.3.2
! NOTE !
For the maintenance operations regarding the hydraulic control unit,
please refer to the manufacturer’s annexed documentation.
7.3.1. Cleaning the lifting platform
Clean the LP thoroughly using compressed air or a dry paintbrush, especially the accessory connection
zones and the safety catch zone.
Use a rag to thoroughly clean the wheels’ “tracks” (on the base and on the frame) and grease them with
common grease.
Use a rag, either dry or lightly soaked with a detergent solution, to clean the towing arm.
! ! ATTENTION! !
Do not use any types of paint solvents and/or direct streams of water
to clean the equipment. It is recommended to use a cloth
lightly soaked with gasoline or kerosene.
To Next Page
Loading...
