GLOBALJIG INTERNATIONAL S.r.l.
28
9. INSTRUCTIONS FOR DISMANTLING AND DISPOSING OF THE LIFTING PLATFORM
9.1. Removing the connections of the lifting platform
Before performing any kind of intervention upon the LP, completely disconnect its energy sources.
Disconnect the system's connection tubes between the control unit and the LP.
Oil supply tube - limit switch cable
Compressed air supply tube - electrical cable
9.2. Preparing the lifting platform for handling and transport
In reference to the procedure indicated in section 4.3, the same operations can be performed in the opposite
order in order to prepare the LP for handling.
In order to handle the machine by means of lifting, refer to the photo and respect the type of equipment, the
methodology and the position scrupulously.
If the LP is to be transported, it must be packed according to that which is described in section 4.1.
9.3. Disposal of the lifting platform
The parts of the lifting platform, which are made up of mechanical components, made from steel alloys and
aluminium, and electrical components (control unit), must be disposed of through specialized companies
and/or facilities and in compliance with the current regulations in the machine’s country of use.
It is recommended to separate the materials in order to facilitate their storage and/or recycling.
! NOTE !
The oil contained within the hydraulic circuit must be disposed
of separately, in compliance with the toxic/harmful waste
disposal regulations in the machine’s country of use.
To Next Page
Loading...
