GLP impression X5 - Range, Display, and User Settings

German Light Products®
Rev. 20220720-01 21
Pan Range
The X5 can move the yoke to the mechanical end positions. However, for normal use
and to make swapping fixtures easier, pan is normally limited to a standard 540°
maximum pan angle.
However, for special applications (for example to get a greater pan angle or if an
accessory is installed) it is possible to adjust the maximum pan angle. Two settings are
available:
● Normal (default): Pan = 540°
● Extended: Pan = 650° (mechanical maximum)
Accessories and tilt range
If an external accessory is installed on the head, it may be necessary to limit the
fixture’s tilt angle. The following settings are available:
● None (default): The tilt angle is not limited: Maximum tilt angle is possible.
● Egg Crate: Maximum tilt angle is limited to allow the installation of an optical
accessory such as the GLP Egg Crate Extension.
● Snoot: Maximum tilt angle is limited to allow the installation of an optical accessory
such as a Snoot.
Display Mode
Gives different display behavior options. This can be helpful in case of errors or service
situations.
● Auto (default): In this setting, the display automatically switches off after a few
seconds if the fixture is receiving a valid control signal and has not detected an
error. If the fixture is not receiving a valid control signal, the display will flash. If the
fixture has detected an error, the display remains constantly on and shows the
error.
● On: The display stays on constantly. This setting can be useful if you are configuring
or servicing the fixture.
● Off: The display will automatically switch off after a few seconds even if the fixture is
not receiving a valid control signal or if it has detected an error. Pressing any button
turns on the display again.
Display Orientation
Lets you select Normal, Upside-down or Auto display orientation.
If Display Orientation is set to Auto, changing the display orientation by pressing UP and
DOWN at the same time will only change the display orientation until the next power
cycle.
Hibernation
Lets you put the fixture into energy-saving mode and disables all electronic
components apart from the DMX receiving module. You can take the fixture out of