GLP impression X5 - Error codes

www.glp.de DMX control modes overview
36 impresssion X5 User Manual
7. Error codes
The impression X5’s self-diagnosis system can display the following error codes:
Code
Comment
Action
HEAT
Overtemperature condition
detected. Fixture will be
powered off and cooldown
sequence will be initiated.
Disconnect fixture from power.
Find reason for overheating and
rectify.
MEMER
Communication with onboard
flash memory not possible, or
written data in flash memory
cannot be read properly
(inability to read flash data can
be due to end of flash memory
lifetime)
Disconnect fixture from power.
Discuss issue with GLP Support.
FANER
Fan error
Disconnect fixture from power.
Find reason for fan error and
rectify. If necessary, discuss issue
with GLP Support.
NETER
Network engine error
Disconnect fixture from power.
Discuss issue with GLP Support.
VERER
Version error – mismatch of one
or more driver version
numbers from the expected
packet version numbers
Disconnect fixture from power.
Check currently available
firmware for fixture. Discuss issue
with GLP Support.