www.glp.de
24 impresssion X5 User Manual
This level contains the following items:
● Service Mode: Disables pan, tilt and all display timeouts to make servicing inside the
fixture head mechanics easier. This mode is automatically disabled after a power
cycle.
● Job Offset: Lets you set +/- offsets on mechanical effects. Custom offsets let you
adjust fixtures in multiple installations to compensate for the different positions of the
fixtures in the rig, for example.
Custom offsets that you create here will not affect the fixture’s effect calibration.
All custom offsets created here are deleted if you apply a Load Factory Defaults
command.
● Reset Counters: Resets the different resettable fixture counters.
Device counters are not deleted by a Load Factory Backup command.
● Save Settings: Lets you save the current fixture settings to one of the three user
settings presets. You can load a user settings preset that you have saved with a
Load User Settings command (see Fixture Settings → Load User Settings). The default
fixture preset cannot be changed.
● Firmware Push (Fixture2Fixture): Pushes the fixture’s firmware (flash storage) to all
other fixtures of the same type via the DMX link.
Load Factory Defaults
Reloads all factory defaults over the entire fixture and brings the fixture into standard
show condition.
You must confirm the function for 3 seconds before the default settings are loaded.
Important! The factory default settings that are reloaded with this command include all
data and network configuration parameters such as DMX start address, IP
configuration etc. You may therefore lose communication with your controller.
The Load Factory Defaults command does not affect device counters and calibration.
Factory Menu
Important! Do not enter the Factory Menu if you are not a trained service professional
with service documentation or clear instructions from GLP Service. Read the user and
service documentation carefully before entering this menu. In the Factory Menu you
can apply critical settings which can damage the fixture.
The Factory Menu is a hidden menu for the manufacturer or professional service
technicians only. This special menu allows fixture calibration and the adjustment of all
mechanical features following the manufacturer’s instructions.
To enable the Factory Menu, apply power to the fixture and press the ENTER and BACK
buttons together while the pre-boot screen is being displayed. You can release the
buttons as soon as FACTORY MODE appears in the black display. After doing this,
Factory Menu is visible as the last item in the main menu. The Factory Menu will remain
available until the next power cycle. While the Factory Menu is enabled, all display
timeouts are disabled to make working on the fixture easier and a Factory symbol is
visible in the main screen.
To Next Page
Loading...
