GLP impression X5 - Page 35

German Light Products®
Rev. 20220720-01 35
Service
Live diagnostic
Shows overview of fixture
information
iQ.Service Connect
>>> Connect <<<
Enables connectivity to
the GLP iQ.Service app.
Tests
Test All
Run test sequence of all
effects including pan and
tilt. Stop with BACK.
Test P/T
Run test sequence of pan
and tilt only. Stop with
BACK.
Test LED
Run test sequence of all
LEDs. Stop with BACK.
Test Zoom
Run test sequence of
zoom effect. Stop with
BACK.
Test Fans (Auto)
Run fan self test. Tries to
detect fan errors, clears if
successful.
Test Fans (Manual)
Manually test fans one by
one
Test Encoders
Auto test for all encoders
Advanced
(Press and
hold for 3
secs.)
Service Mode
OFF
Normal operation
ON
Disable pan, tilt and
display timeouts (exit by
cycling power off and on.)
Job offsets
Pan
Tilt
Zoom
Create custom offsets in
home positions of all
effects. Default offset = 0
Reset counters
Device
hours
Confirm 2
seconds
Zero the device hours
counter
Device
power
cycles
Confirm 2
seconds
Zero the power cycles
counte
Max.
tempera-
tures
Confirm 2
seconds
Zero the max.
temperatures log (total
max. temperatures = non-
resettable, max.
temperatures = resettable)
Air filter
Confirm 2
seconds
Zero the air filter hours
counter
Save User Settings
Preset 1
Confirm 2
seconds
Saves current fixture
settings as user settings
preset
Preset 2
Confirm 2
seconds
Preset 3
Confirm 2
seconds
Firmware push
(Fixture2fixture)
>>> Confirm <<<
Push fixture’s firmware to
all other fixtures of the
same type over the DMX
link
Load factory defaults
>>>Confirm<<<
Reloads all factory default
settings and default fixture
configuration settings.
Default settings are written in BOLD type