Page 23 of 52
5. OPERATING INSTRUCTIONS & FUNCTION TESTS
DO NOT operate this machine until you have read and understood this manual, have performed the Workplace
Inspection, Prestart Inspection and Routine Maintenance, and have completed all the test operations detailed in the
Operating Instructions section.
This section provides instructions and tests for each function of machine operation. Follow all safety rules and
instructions. The operator must conduct inspections and a Functions Test of the machine before each work shift to
check that all machine systems are working properly.
Test the machine on a firm level surface with no debris, drop-offs, potholes or overhead obstructions. Perform each
step outlined in this section.
This machine shall only be operated by trained and authorized personnel. If multiple operators use this machine, all
must be trained, qualified and authorized to use it. New operators must perform a Pre-Start Inspection and Functions
Test prior to operating the machine.
Operators must comply with all employer and job site rules and governmental regulations regarding the use of
personal protective equipment.
DO NOT use a machine that is malfunctioning. If any function does not perform as described, tag the machine and
remove for repair by a qualified service technician.
5.1 PRESTART
• Perform Prestart Inspection.
• Check EMERGENCY STOP at both the lower and platform controls turn clockwise to reset.
5.1.1 FUNCTIONS TEST
5.1.2 AT THE LOWER CONTROLS
5.1.3 TEST EMERGENCY STOP
Operating Instructions & Function Tests
1. Select a test area that is firm, level and free of obstruction.
2. Be sure the battery pack is connected.
3. Turn the EMERGENCY STOP clockwise to set it to the ON position.
4. Set the KEY SWITCH at the lower controls at LOWER controls
5. Push the EMERGENCY STOP to set it in the OFF position.
6. When EMERGENCY STOP is pressed in, all functions are disabled - flashing light should
not lit.
7. Turn the EMERGENCY STOP clockwise to set it to the ON position.
8. When EMERGENCY STOP is set to ON - all functions are enabled - flashing light should
blink.
To Next Page
Loading...
