GMG 1930ED - 4646ED
Operator’s manual
Operator’s Manual - 1930----4646ED
March 2019 #940400-3-EN
10.2 FREQUENT INSPECTION CHECKLIST
Frequent Maintenance Inspections should be conducted by qualified service technicians only.
Photocopy this page for reuse. Keep inspections records up to date.
Record and report all discrepancies to your supervisor.
See the Service & Parts Manual for specific instructions.
Model Number Serial Number Hour Meter Reading
Initial Description
Additional maintenance requirements for severe conditions
If the machine is used in very dusty, exceptionally hot or exceptionally cold conditions, replace the Hydraulic Cap
Breather Filter and Hydraulic Filter (under normal conditions replace every 6months or 300 hours, whichever
comes first).
Perform all checks listed on Pre-Start Inspection.
Grease the Steering Yokes.
Inspect the condition of hydraulic fluid in the reservoir. Oil should be a clear
and amber in color.
Batteries
Electrial wiring
Tires and wheels
EMERGENCY STOP
Key switch
Horn (if equipped)
Drive brakes
Drive speed - stowed
Drive speed - raised
Drive speed - slow
Tank venting system
Latch Components
Test Down & Pothole limit switches
Test Up limit switches
This checklist must be used at 3-month intervals or every 150 hours of ma-
chine use, whichever occurs first. Failure to do so could result in death or
serious injury.
To Next Page
Loading...
