Page 43 of 52
10. INSPECTIONS
The operator conduct a Pre-Start Inspection of the machine before each work shift. DO NOT use a damaged or mal-
functioning machine.
Initial Description
Check the following components or areas for damage, improperly installed or
missing parts and unauthorized modifications:
Check entire machine for:
Be sure that the operator’s manual is complete, legible and in the storage
container located in the platform.
Be sure that all decals are legible and in place.
Check for hydraulic oil leaks.
Check for battery fluid leaks.
Electrical components, wiring and electrical cables
Battery connections
Electrical components, wiring and electrical cables
Battery pack and connections
Drive motors
Slide blocks/wear pads
Tires and wheels
Ground strap
Limit switches, alarm and beacon
Nuts, bolts and other fasteners
Platform entry gate
Beacons and alarms
Maintenance Lock
Platform extension
Scissor pins and retaining fasteners
Platform control handle
Brake release components
Pothole guards
Cracks in welds or structural components
Dents or damage to machine
Be sure that all structural and other critical components are present and all associ-
ated fasteners and pins are in place and properly tightened
Be sure that guard rails are properly installed and secured, and that all pins
and bolts are properly fastened.
Be sure that the chassis trays are closed and latched and
the batteries are properly connected.
NEVER perform work or inspection on the machine with the platform elevated
without first blocking the scissor assembly with the Maintenance Lock.
Inspections
10.1 PRE-START INSPECTION
To Next Page
Loading...
