GMG 1930ED - 4646ED
Operator’s manual
Operator’s Manual - 1930----4646ED
March 2019 #940400-3-EN
9.5 MAINTENANCE LOCK
1 Raise the platform approximately 2.2m from the ground
2 Rotate the Maintenance Lock(s) and allow it/them to hang straight down.
3 Lower the platform until the Maintenance Lock(s) rests securely on the link.
Keep clear of the Maintenance Lock when lowering the platform.
Stow the Maintenance locks by raising the platform slightly and rotating them to the stowed position.
DEATH OR SERIOUS INJURY HAZARD!
NEVER perform work or inspection on the machine with the platform elevated
without first blocking the scissor assembly with the Maintenance Lock. On
machines equipped with two Maintenance Locks, BOTH must be set to safely
work on or inspect the machine. BOTH Maintenance Locks must be stowed
before lowering the platform.
DO NOT attempt to lower the platform with one maintenance lock in place.
DO NOT engage the Maintenance Locks unless the platform in empty of tools
and material.
DE-6464 & DE-6404 ,DE-6433DE-2362 & DE-0391
The 3346-ED, 4046-ED and 4646-ED
machines have two Maintenance Locks,
located at the machine rear and front.
The1930-ED and 2632-ED
have one Maintenance Lock,
located at the machine rear.
Maintenance
Lock
Maintenance
Locks
To Next Page
Loading...
