Section
3394RT---6094RT Scissor Lifts - Operator’s Manual Page 27
10 - Machine Inspections and Maintenance
Montly Inspection Checklist
Initial Description
Perform all checks listed on Prestart Inspection.
Inspect the condition of hydraulic fluid in the reservoir. Oil should have a clear amber color.
Check battery electrolyte level and connections.
Check wheel lug nuts for proper torque (see Machine Specifications).
Check if tires are leaning in or out.
Inspect all beams and pivot points for signs of wear and/or damage.
Check the pin joints and retaining rings for security.
Inspect the entire machine for signs of damage, broken welds, loose bolts, improper or makeshift repairs.
Check that the platform does not drift down with a full load.
Lubricate the axle float cylinder pivot mounts (see Lubrication Chart).
Check all wire connections.
Check that all adjustable flow valves are locked, check setting if any are not locked.
Check outriggers for proper operation (if equipped).
Scheduled Maintenance Inspections should be conducted by qualified service technicians only. Photocopy
this page for reuse. Keep inspections records up to date. Record and report all discrepancies to your
supervisor.
Model Number Serial Number Hour Meter Reading
This checklist must be used at monthly intervals or every 100 hours of machine
use, whichever occurs first. Failure to do so could result in death or serious
injury. The frequency and extent of periodical examinations may depend on
national regulations.
DATE INSPECTED BY
To Next Page
Loading...
