Section
3394RT---6094RT Scissor Lifts - Operator’s Manual Page 34
12 - Troubleshooting
Never perform service on the machine with the platform elevated without first
blocking the scissor assembly using the maintenance lock.
Should you experience erratic operation or notice any malfunction while
operating this machine, discontinue use immediately.
Call for assistance and report the incident to your supervisor, and do
not use the machine until it has been checked by a trained, qualified
mechanic.
Machine functions will not operate
• Battery properly connected?
• Battery fully charged?
• Function toggle switch or the Enable Switch not activated?
• Selector Key Switch in proper position?
• Both Emergency Stop Switches reset?
• Hydraulic fluid level low?
• Obvious fluid leak or damaged component?
• Wires disconnected, broken, or loose?
• Motor control processor Diagnostic LED OFF?
LED should be ON. If not N or FLASHING, refer to Service Manual or contact GMG Technical Support.
Troubleshooting
To Next Page
Loading...
