Section
3394RT---6094RT Scissor Lifts - Operator’s Manual Page 29
10 - Machine Inspections and Maintenance
3394-RT and 6094-RT Annual Inspection Report
Inspector Company Date
Serial Number
Model Number
Date of Last Inspection
Date placed in service
Check each item listed below. Use Brochures, Operator & Service Manuals, and Machine Setting Work Instructions for specific instructions.
Legend: Y = Yes / Acceptable R = Repaired N = No / Unacceptable Ø = Not Applicable
DECALS:
YNRØ
SIDE MODULES:
YNRØ
Proper placement Valve manifolds secure
Legibility Hoses tight no leaks
Correct capacity noted Batteries secured and charged
PLATFORM RAILS:
YNRØ
Batteries cables tight
All rail fasteners secure Batteries fluid level correct
Entry gate(s) closes properly Batteries load tested
Manual / Safety data in manual box No water or condensation present in lower control panel
Ensure manual box is installed in correct location Wire connections all tight
PLATFORM AND EXTENSION DECKS:
YNRØ
All control panels and switches secure
Both extension decks slide freely Module doors close securely
Both extension decks latch stowed and fully extended Hydraulic oil level correct
Door and rail latches work properly Diesel fuel level full
Cables secure Hyd. Steering pressure set
Platform bolts tight Hyd. Drive pressure set
Platform secure Hyd. Lift pressure set
WIRE HARNESSES:
YNRØ
ENGINE COMPARTMENT & FLUIDS:
YNRØ
Wire harnesses mounted correctly, no evidence of damage Slide tray and hand latches work properly
All connections tight, no frayed wires present Engine radiator, grill, exhaust pipe, and ECU mounts tight
110/220V Outlet working properly Engine oil and filter replaced and filled to correct level
ELEVATING ASSEMBLY:
YNRØ
Hyd oil filter and fuel filter replaced
No weld damage or failure in scissor beam structures Fuel / water seperator cleanand inspected
All retaining ringsfully locked in place with no damage Fuel lines, fuel pump secure and free from leaks
All cylinder pins and locking pins secure with no damage Engine air filter cleaned and inspected, replace if needed
Lower and upper beam mounts secure and pads slide freely Side and top shields in place and secure
Ensure maintenance lock is secure and functions properly Alternator output between 13.0v-14.5v
BASE:
YNRØ
Engine starts quickly
Front and rear axle mount bolts tight OPERATIONS:
YNRØ
Front and rear wheel motor mounts secure Master cut off switch cuts all power to all functions
Drive motors not leaking oil, and oil to correct level Hour meter functional
Lug nuts torqued Warning light and horns functional
Steering pins secured No vibration with engine idling
All pivot points lubed Emergency stop switch stops all circuits
Brakes operating properly Emergency down operates properly
Axle lock operational Machine drives / lifts / steers / stops as specified
Base fasteners tight All installed options operate properly
Cover panels secure All functions operate smoothly
Signature Owner/User
Machine does not make unusual noise in any operation
Signature Mechanic
Overall appearance is good
Machine Passed Inspection, YES / NO:
Notes:
City/State/Zip
Contact
Customer
Street
City/State/Zip
Phone Number
Contact
Street
Phone Number
To Next Page
Loading...
