GMI GT series - Leak Test Mode Operations; Leak Test Features

25
Fig. 2.7 Enter Calibration Code
If the Field Calibration option is disabled in the instruments
configuration, the message, shown in Fig. 2.8, will be
displayed briefly. Field Calibration is only available if
enabled in configuration.
Fig. 2.8 Calibration Disabled
2.2.1 Enter Calibration Code
To enter the Calibration code (333):
 Press the UP or DOWN buttons to alter
the highlighted digit.
 Press NEXT to select the next digit.
 When all three digits have been entered, press OK
to accept.
FIELD CALIBRATION