GMI GT series - Enter the Alarm Code

39
Fig. 3.7 Enter Alarm Code
3.2.1 Enter the Alarm Code
To enter ALARMS code (123):
 Press the UP or DOWN buttons to alter
the highlighted digit.
 Press NEXT to select the next digit.
 When all three digits have been entered, press OK
to accept.
The following Table 3.1 shows the GMI default selections.
Latching or non-latching options exist in all allowable
alarms.
Alarms are allowed in Leak Mode and CSM Mode.
Any single alarm, e.g. LEL Hi, Toxic Warning etc., can
only have one alarm concentration level and either latching/
non latching, mute or non mute. The output , i.e. display,
Lo Pitch / Hi Pitch with LEDs flashing / ramping are preset
according to the following Table 3.1.
ALARM CONFIGURATION