Need help?Do you have a question about the GMI PS200 series and is the answer not in the manual?
General| Display | LCD |
|---|---|
| Alarm Type | Audible, visual, and vibration alarms |
| Resolution | Depends on the gas being detected |
| Accuracy | Varies depending on the gas and sensor. Consult the specific sensor datasheet. |
| Operating Temperature | -20°C to +50°C |
| Power Supply | Rechargeable Li-ion battery |
| Pump Type | Built-in sample pump |
Covers responsibility and consequences of handbook use.
Informs about product changes and handbook updates.
Details software usage rights and restrictions.
Guidance on proper instrument disposal and environmental respect.
Specifies environments where the instrument can be used, including limitations.
Outlines specific operational requirements and precautions.
Instructions for storing and transporting the device safely.
Overview of the PS200 series gas detector.
Key characteristics and capabilities of the instrument.
Functionality for recording measurements, events, bump/calibration data.
Information on protective instrument filters for dust and water ingress.
Details on the instrument's tough, impact-resistant housing.
Describes the label on the instrument's rear with serial and certification details.
Specifications like weight, dimensions, operating temperature, and humidity.
Details of relevant certifications and standards (ATEX, IECEx, UL, MED).
Step-by-step guide for using the instrument before operation.
Instructions for powering up the device and its warm-up routine.
Information displayed during warm-up, including serial and battery status.
How to check the battery charge level via a bar graph.
Configuring user identification for logs.
Using the motion detection feature for safety.
Display of the instrument's internal clock during warm-up.
Checking the instrument's calibration status and expiry.
Procedure to select the calibration gas type for accurate readings.
Verifying sensor zeroing status before operation.
Screen display configuration during normal operation.
Manually controlling screen brightness for visibility.
Accessing stored maximum and minimum gas readings.
How to manage and clear active alarms.
Using the instrument for remote gas detection with a pump.
Performing diagnostic tests on the instrument's functions.
Instructions for powering down the device safely.
Explains the purpose of bump testing sensors for response verification.
Describes the QUICK and FULL bump test types.
Steps to start a bump test procedure.
Procedure for introducing test gas to the instrument.
Details dependent on the configured test type (QUICK or FULL).
Confirming alarms during a bump test.
Interpreting the outcome of a bump test (PASS/FAIL).
General overview of gas detection alarms and their indicators.
How to clear active gas alarms and reset the system.
Functionality to silence audible alarms temporarily.
Specific alarm for high flammable gas readings exceeding limits.
Types of instrument malfunctions and their corresponding indicators.
Specific alarm for motion detection failure.
Instructions for cleaning the instrument casing safely.
Procedure for replacing internal filters protecting the sensors.
Methods for charging the device battery using GMI chargers.
List of items included with the product.
List of optional accessories for purchase.
Information on available training courses and contact details.
Links to GMI websites for more information.
To Next Page
