GMI PS200 series User Manual

1-6
USER HANDBOOK
The instrument can store in excess of 24 hours of readings at
a recording interval of 1 minute, 180 On / Off event logs and
alarms, 180 bump test logs and 8 calibrations.
1.3.1 Archiving Stored Readings
Stored readings can be downloaded from the PS200 series
instrument to a PC, using the standard charging / comms
cable and additional software. Contact the GMI Sales
Department for further details.
1.4 FILTERS
The instrument is protected from water and dust ingress by
hydrophobic and dust (sample inlet) filters.
These filters should be checked regularly and replaced if
necessary (refer to ‘FILTER REPLACEMENT’ section in
Chapter 5 ‘OPERATOR MAINTENANCE’).
1.5 CONSTRUCTION
The PS200 series is housed in a tough, impact resistant
moulded case. Sealed to IP67, it can withstand physical impact
testing to EN 61779.

GMI PS200 series Specifications

General

Display	LCD
Alarm Type	Audible, visual, and vibration alarms
Resolution	Depends on the gas being detected
Accuracy	Varies depending on the gas and sensor. Consult the specific sensor datasheet.
Operating Temperature	-20°C to +50°C
Power Supply	Rechargeable Li-ion battery
Pump Type	Built-in sample pump