EasyManuals Logo

GMI PS200 series User Manual

GMI PS200 series
88 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #67 background imageLoading...
Page #67 background image
6-1
OPERATOR MAINTENANCE
RECHARGE BATTERY
6.1 RECHARGE INSTRUMENT BATTERY
Use only GMI chargers to recharge PS200 series
instruments.
CAUTION: Switch the instrument off when charging
the internal battery.
The battery should be recharged in the following situations:
The ‘LOW BATTERY’ flag appears on the
display
The instrument will not switch On
When the ‘LOW BATTERY’ icon appears on the display, there
is approximately 30 minutes operation left at normal
temperatures. The instrument will then switch Off
automatically.
There are three options available to the user to charge
the PS200 instrument battery, as follows:
1) Using the Charging Comms Clip (Part No. 64260)
together with the Mains Adaptor and cable (Part No.
64247) supplied with the instrument.
2) Charging the instrument in the Auto Bump /
Calibration Station (Part No. 64122 / 64122Q).
6

Table of Contents

Other manuals for GMI PS200 series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the GMI PS200 series and is the answer not in the manual?

GMI PS200 series Specifications

General IconGeneral
DisplayLCD
Alarm TypeAudible, visual, and vibration alarms
ResolutionDepends on the gas being detected
AccuracyVaries depending on the gas and sensor. Consult the specific sensor datasheet.
Operating Temperature-20°C to +50°C
Power SupplyRechargeable Li-ion battery
Pump TypeBuilt-in sample pump

Related product manuals