To Next Page

To Previous Page

5-3

OPERATOR MAINTENANCE

3) Fit a new Hydrophobic Filter (Part No. 64254).

4) Carefully place the hydrophobic filter in position over

the instrument sensors, locating filter pin holes over

locating pegs in instrument filter recess.

5) Place the filter cover over the filter recess then

carefully slide it towards the display screen until the

lugs are located in the mating slots in the instrument

filter recess. Press the cover down on to the filter

then, using a No.1 Pozidrive

screwdriver, tighten

the captive screw until secure.

Note: Care must be taken not to overtighten the cover

screw.

5.2.2 Replace Sample Inlet (Dust) Filter

SAMPLE

INLET FILTER

(Part No. 64084)

INLET NOZZLE ASSEMBLY

QUICK CONNECT

POZI PAN SCREW (2)

Fig. 5-2 Replace Inlet Filter

Other manuals for GMI PS200 series

Questions and Answers:

Need help?

Do you have a question about the GMI PS200 series and is the answer not in the manual?

General

Display	LCD
Alarm Type	Audible, visual, and vibration alarms
Resolution	Depends on the gas being detected
Accuracy	Varies depending on the gas and sensor. Consult the specific sensor datasheet.
Operating Temperature	-20°C to +50°C
Power Supply	Rechargeable Li-ion battery
Pump Type	Built-in sample pump