GMP PROTOPIC III-540 - Perforating and Cutting Issues

TROUBLE SHOOTING
Trouble Type Reason How to solve
Cutting roller does not work
1. Cutting roller motor's disorder or
1. Contact dealer or A/S Center
Conveyer belt is broken
2. FUSE is disconnected 2. Exchange the enclosed fuse.
3. Compressor's malfunction 3 Contact dealer or A/S Center
Laminating results' cutting 1. Cutting edge of perforator is not sharp 1. Adjust the cutting edge using height control bolt
Status is not good
Refer to the Perforator "Perforator Control"
2. Cutting roller pressure is not good 2. Adjust the height of rollers using Cutting roller height control Knob
Refer to the "Cutting roller height control Knob"
3. Cutting timing is not regular
3. Timing resetting using "DISTANCE" button on control panel
Functional Adjustment refer to "DISTANCE" part
4. When not using POLYNEX(OPP) film 4. Contact dealer or A/S Center
Cutting is not good
5. In case of using NYLONEX(NYLON),
5. Using "BURST SPEED" button on control panel, rotate the cutting roller
PERFEX(PET)
at high speed.
Refer to the functional Part "BURST SPEED"
Perforating
34/48