Gocycle
®
Owner’s Manual for G2, August 2015
© Karbon Kinetics Limited. All Rights Reserved. 41
6.3.2 Selecting a Riding Mode
Refer to the table in 6.3.1 Riding Modes Reference Table.
To view current mode of operation, press and hold buttons A and B. The current mode of operation,
displayed by a number of LEDs, will show on the dashboard display (C).
To select a riding mode, press and hold buttons A and B until all LEDs flash, then release both
buttons. The mode will then be shown on the dashboard display (C). Click button B repeatedly until
you reach the number of LEDs which represent your desired mode (C). To save the mode, press and
hold button A until LEDs flash and then release the button.
WARNING! Do not attempt to change a riding mode whilst in motion. Attempting to change the mode
whilst riding will severely impair rider concentration and will dramatically increase the chance of an
accident, which may result in injury to the rider or even death.
6.3.2.1 City Mode
City mode utilises your Gocycle’s torque sensor, with the motor assistance level controlled by rider
pedal input. (Hard pedalling = high motor assistance, soft pedalling = less motor assistance).
In this mode, within the motor operating speed and whilst the rider is providing pedal input, the
motor will start automatically and will continue to operate until the maximum speed is reached.
For maximum motor assistance, press and hold the red power button.
Above the maximum motor speed, the motor will stop. There is no need to press the red power
button. When the pedals cease to rotate or with reduced pedal input, the motor will stop.
WARNING! The motor will continue to operate while the rider exerts pedal effort and is travelling
within the motor operating speed. To stop the motor, cease pedalling, or reduce pedal effort.
Control motor assistance level—must be turning
Medium pedal effort, or press and hold red power button
Top Speed (Motor Cut-Out Speed)
6.3.2.2 Eco Mode
Eco mode operates in the same manner as City mode, but the rider must pedal harder to gain
assistance. Use this mode if you wish to conserve your battery and increase your range.
In this mode, within the motor operating speed and whilst the rider is providing pedal input, the
motor will start automatically and will continue to operate until the maximum speed is reached.
For maximum motor assistance, press and hold the red power button.
To Next Page
Loading...
