Gocycle G3 - Page 53

Gocycle
®
Owner’s Manual for G3, March 2016
© Karbon Kinetics Limited. All Rights Reserved. 49
6.3.2.4 Eco + (Custom Mode)
The factory default setting for Custom mode is Eco+, which operates in the same manner as Eco mode,
but the rider must pedal harder to gain assistance. Use this mode if you wish to further conserve your
battery and increase your range.
In this mode, within the motor operating speed and whilst the rider is providing pedal input, the
motor will start automatically and will continue to operate until the maximum speed is reached.
For maximum motor assistance, rotate “wrist down” selector A.
Above the maximum motor speed, the motor will stop. There is no need to rotate “wrist down”
selector A. When the pedals cease to rotate or with reduced pedal input, the motor will stop.
Mode
Custom
Eco+ (Factory Default)
LED Mode Display
4
4
Left-hand Selector A
Customisable via Gocycle App
See www.gocycle.com/app for
more information
Need not be rotated “wrist down”
Pedals
Control motor assistance level—must be
turning
Motor Start
Medium/High pedal effort
Maximum Motor Assistance
High pedal effort, or press and hold red
power button
Top Speed (Motor Cut-Out
Speed)
Up to 15.5mph (25km/h)
Custom mode enables a rider to edit various mode settings including;
 Pedal effort required for motor to start
 Pedal effort required for maximum motor assistance
 Maximum speed
 Pedalling required for motor assistance ON/OFF
 Updating firmware
 Fault diagnosis
Gocycle is Bluetooth
®
-enabled and requires the Gocycle App to connect via a smart device. The user
can personalize the settings via the App and save the settings to suit the user’s riding style and
assistance preferences.
For more information, please visit www.gocycle.com/app or contact your local reseller.
WARNING! It is possible to edit the Custom mode to deliver a speed that is greater than the
maximum speed defined by the European EPAC standard EN 15194.
Consult your local transport authority for information on legal restrictions.