61
3. Whether the distance between the flash trigger and the flash is too
close or not (
<
0.5m).
4. Whether the flash trigger and the receiver end equipment are in the low
battery states or not
5. The flash trigger’s rmware is an older version
6. The camera’s rmware is an older version
→
Please turn on the “close distance wireless mode”:
→
Please replace the battery or charge it in time.
→
Please upgrade the rmware of the flash trigger referring to the
instruction manual for specic rmware upgrades.
→
Please upgrade the rmware of the camera referring to its instruction
manual.
X1 Series: Press and hold the triggering button then turn on the device until
the indicator blinks twice.
Xpro and X2T Series: Set the C.Fn-DIST to 0-30m.
X3 Series: Set the triggering distance to 0-30m.
The Reason & Solution of Not Triggering in Godox
2.4G Wireless
1. Disturbed by the 2.4G signal in outer environment (e.g. wireless base
station, 2.4G wi router, Bluetooth, etc.)
2. Please make sure that whether the flash has nished its recycle or
caught up with the continuous shooting speed or not (the flash ready
indicator is lightened) and the flash is not under the state of over-heat
protection or other abnormal situations.
→
To adjust the channel CH setting on the flash trigger (add 10+ channels)
and use the channel which is not disturbed. Or turn off the other 2.4G
equipment in working.
→
Please downgrade the flash power output. If the flash is in TTL mode,
please try to change it to M mode (a pre-flash is needed in TTL mode).
To Next Page
Loading...
