60
Protection Function
To avoid overheating and deteriorating the flash head, do not re more
than 70 continuous flashes in fast succession at 1/1 full power. After 70
continuous flashes, allow a rest time of at least 10 minutes.
If you re more than 70 continuous flashes and then re more flashes
in short intervals, the inner over-temperature protection function may
be activated and make the recycle time over 10 seconds. If this occurs,
allow a rest time of about 10 minutes, and the flash unit will then return to
normal.
When the over-temperature protection is started, < > is shown on the LCD
display.
Power Output Level
1/1
1/2 (+0.1~+0.9)
1/4(+0.1~+0.9)
1/8(+0.1~+0.9)
1/16(+0.1~+0.9)
1/32(+0.1~+0.9)
1/64(+0.1~+0.9)
1/128(+0.1~+0.9)
1/256(+0.1~+0.9)
Display
Error1
Error3
Error5
Error9
Number of Flashes
60
70
100
Meaning
A failure occurs on the recycling system so that the flash cannot re. Please
restart the flash unit. If the problem still exists, please send this product to a
maintenance center.
The voltage on two outlets of the flash tube is too high. Please send this
product to a maintenance center.
Abnormalities in the flash circuit. Please send this product to a maintenance
center.
There are some errors occurred during the upgrading process. Please using
the correct rmware upgrade method.
Over-Temperature Protection
Number of flashes that will activate over-temperature protection:
Number of flashes that will activate over-temperature protection in
HSS mode:
Other Protections
The system provides real-time protection to secure the device and your
safety. The following lists prompts for your reference:
●
●
●
Flash Power
Focal Length
Number
of Flash
1/1
1/2
1/4
1/8
1/16
1/32
1/64
1/128
1/256
28mm
70
106
215
300
1200
3500
35mm
75
114
231
300
1200
3500
50mm
80
120
240
300
1200
3500
70mm
90
134
273
300
1200
3500
80mm
100
150
300
300
1200
3500
105mm
100
150
300
300
1200
3500
To Next Page
Loading...
