Godox V1C - Protection Function; Over-Temperature Protection Details

35
Protection Function
Over-Temperature Protection
• To avoid overheating and deteriorating the flash head, do not fire more than 30
continuous flashes in fast succession 1/1 full power. After 30 continuous flashes,
allow a rest time of at least 10 minutes.
• If you fire more than 30 continuous flashes and the fire more flashes in short
intervals, the inner over-temperature protection function may be activated. If this
occurs, allow a rest time of about 10 minutes, and the flash unit will then return
to normal.
• When the over-temperature protection is started is shown on the LCD display.
Number of flashes that will activate over-temperature protection:
Power Output Level
Number of Flashes
1/1
30
1/2+0.7
40
1/2+0.3
50
1/2
60
1/4(+0.3, +0.7)
100
1/8(+0.3, +0.7)
200
1/16(+0.3, +0.7
300
1/32(+0.3, +0.7)
500
1/64(+0.3, +0.7)
1000
1/128(+0.3, +0.7)
Number of flashes what will activate over-temperature protection in high-
speed sync triggering mode:
Power Output Level
Times
1/1
15
1/2(+0.3, +0.7)
20
1/4(+0.3, +0.7)
30
1/8(+0.3, +0.7)
1/16(+0.3, +0.7
40
1/32(+0.3, +0.7)
1/64(+0.3, +0.7)
50
1/128(+0.3, +0.7)