Godox V1C - Flash Mode: E-TTL AutoFlash; ETTL Mode Operation; Flash Exposure Compensation (FEC)

15
Flash Mode—E-TTL AutoFlash
This flash has three flash modes: E-TTL, Manual (M), and Multi (Stroboscopic). In E-TTL
mode, the camera and the flash will work together to calculate the correct exposure for
the subject and the background. In this mode, multiple TTL functions are available: FEC,
FEB, FEL, HSS, second curtain sync, modeling flash, control with the camera’s menu
screen.
*Press <MODE> Mode Selection Button and three flash modes will display on the LCD
panel one by one with each pressing.
ETTL Mode
Press <MODE> Mode Selection Button to enter E-TTL mode. The mode LCD panel will
display.
• Press the camera release button halfway to focus. The aperture and effective
flash range will be displayed in the viewfinder.
• When the shutter button is fully pressed, the flash will fire pre-flash that the
camera will use to calculate exposure and flash output the instant before the
photo is taken.
FEC: Flash Exposure Compensation
With FEC function, this flash can adjust from -3 to +3 in 1/3 stops. It is useful in situations
where minor adjusting of the TTL system is needed based on the environment.
FEC Setting:
Press Function Button 2
Press the <+/-> button. The
< > and flash exposure
compensation amount will
be highlighted on the LCD
panel.
Set the flash exposure
compensation amount.
• Turn the Select Dial
to set the amount.
• “0.3” means 1/3
step, “0.7” means
2/3 step.
• To cancel the flash
exposure
compensation, set
the amount to “+0”.
Press Set Button again to
confirm the setting.