Godox V1Pro C - ID Settings; Scan the Spare Channel; Transmitter Units (Flash) ON;OFF; ETTL: Fully Automatic Wireless Flash Shooting

42 43
Scan the Spare Channel
You can scan the spare channel to avoid the interference of using the same
channel by others.
1. Press <MENU> menu button to
enter menu setting. Turn the select
dial to <SCAN>, then press the set
button to choose SCAN.
ID Settings
Change the wireless channels and wireless ID to avoid interference for it can
only be triggered after the wireless channels and IDs of the transmitter unit
and the receiver unit are set to the same. Press the menu button to enter C.Fn
ID, press the set button to choose OFF to turn off the wireless ID, or choose
any gure from 01 to 99.
2. Turn the select dial to adjust wireless
ID from 01 to 99 or OFF. Press the set
button to conrm.
1. Press <
MENU
> menu button to
enter menu setting. Turn the select dial
to <ID>, then press the set button to
choose ID.
C.Fn Ver 0.2
CLEAR
CH
ID
BEEP
STBY
99
SCAN
Transmitter Unit's (Flash) ON/OFF
You can set whether the transmitter unit (flash) that transmits wireless signal
flashes or not, and when the transmitter unit flash setting is on, the flash res
as a flash A group.
2. Turn the select dial to choose
START, then press the set button to
scan. And the 8 spare channels will
be displayed for your choice.
1. Press <MENU> menu button to
enter menu setting. Turn the select
dial to < TX>, then press the set
button to choose TX.
C.Fn Ver 0.2
CLEAR
CH
ID
BEEP
SCAN
22 08 32 23
30 21 07 06
2.Turn the select dial to choose < > or
<
>，Press the set button to conrm.
<
>：The transmitter unit ash ring
is OFF.
<
>：The transmitter unit ash
ring is ON.
Note: Even if the transmitter unit flash ring is off, it still transmits wireless flash signals.
C.Fn Ver 0.2
CLEAR
LCD
FEB ACL
TX
STBYLIGHT
ETTL: Fully Automatic Wireless Flash Shooting
Using Automatic Wireless Flash with a Single Receiver Unit
1. Transmitter Unit Setting
Press the wireless button and the
<
> icon is displayed on the LCD
panel, then the V1Pro C attached to
the camera is set as the transmitter
unit.
X2T-C can also be set as transmitter
unit. X2T-C can control V1Pro C's
ZOOM value when the ZOOM is
adjusted to auto (A) mode.
2. Receiver Unit Setting
Press the wireless button and the
<RX> is displayed on the LCD panel,
then the V1Pro C wirelessly controlled
is set as the receiver unit.
3. Check the Communication Channel
Set the wireless channels of transmitter unit and receiver unit to the same.
For example, if the transmitter unit channel is set to 01, then the receiver
unit channel needs to be 01 as well.
4. Position the Camera and Flashes
The transmission distance of the transmitter unit and receiver unit is
about 100m.
5. Set the Flash Mode to <ETTL>
Press the corresponding function
button 1/2/3/4<A/B/C/D > to make
<
TTL
> is displayed on the LCD panel.
The receiver unit controlled by the
transmitter unit will automatically be
set as <
TTL
>.
Transmission distance
is about 100m
Please set the MENU-TX transmitter unit's flash to ON in order to make the
transmitter unit re flashes.