52 53
Firmware Upgrade
1. This product supports rmware upgrade through the USB-C port, please
use USB-C cable (sold separately).
2. As the rmware upgrade needs the support of Godox G3 software, please
download and install the "Godox G3 rmware upgrade software" before
upgrading. Then, choose the related rmware le.
3. Please refer to the latest electronic version of the instruction manual.
Compatible Camera Models
FCC Statement
Maintenance
This flash unit can be used on the following Canon EOS series camera models:
This device complies with part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) This device may not cause harmful interference,
and (2) this device must accept any interference received, including
interference that may cause undesired operation.
Any Changes or modications not expressly approved by the party responsible
for compliance could void the user's authority to operate the equipment.
Note: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates uses
and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or
more of the following measures:
1DX
,
5D
Mark III
,
5D Mark II
,
6D, 7D
,
60D
,
50D
,
40D, 30D
,
650D
,
600D
,
550D
,
500D
,
450D
,
400D Digital
,
1100D, 1000D
,
5D Mark IV, 7D Mark II
,
6D Mark II
,
760D
,
750D, 70D, 80D
,
800D
,
77D
,
M5, M3
,
M50
,
EOS R
,
1500D
,
3000D,
5D II, 5D III, RP, 90D
Shut down the device immediately should abnormal operation be detected.
Avoid sudden impacts and the product should be dedusted regularly.
It is normal for the flash tube to be warm when in use. Avoid continuous
flashes if unnecessary.
Maintenance of the flash must be performed by our authorized maintenance
department which can provide original accessories.
This product, except consumables e.g. flash tube, is supported with a one-
year warranty.
Unauthorized service will void the warranty.
If the product had failures or was wetted, do not use it until it is repaired by
professionals.
Changes made to the specications or designs may not be reflected in this
manual.
1. This table only lists the tested camera models, not all Canon EOS series cameras.
For the compatibility of other camera models, a self-test is recommended.
2. Rights to modify this table are retained.
Note：
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
The device has been evaluated to meet general RF exposure requirement.
The device can be used in portable exposure condition without restriction.
Warning
Operating frequency:2403MHz-2483.0MHz
Maximum EIRP Power:5dBm
Declaration of Conformity
GODOX Photo Equipment Co.,Ltd. hereby declares that this equipment are in
compliance with the essential requirements and other relevant provisions of
Directive 2014/53/EU. In accordance with Article 10(2) and Article 10(10), this
product is allowed to be used in all EU member states.
For more information of DoC, Please click this web link:
https://www.godox.com/eu-declaration-of-conformity/
The device complies with RF specications when the device used at 0mm
from your body.
To Next Page
Loading...
