Goodwe Smart DT Series User Manual

43

Figure3.4.7‐1

3.5Tr oubleshooting
` If the Inverter is not able to work properly, please refer to the following
instructionsbeforecontactyourlocalservice.
` Should any problems arise, the red (FA ULT) LED indicator on the front
panel lights up and the LCD screen will display relevant information.
Please refer to the following table for a list of error message and
associatedsolutions.

Display Possibleactions
System
Fault
IsolationFailure
1. ChecktheimpedancebetweenPV(+)&PV(‐)andmakesure
thePVInverterisearthed.Theimpedancevaluemustbe
greaterthan2MΩ.
2. Contactlocalserviceofficeforhelpiftheproblemstillexists.
已发行

Goodwe Smart DT Series Specifications

General

Brand	Goodwe
Model	Smart DT Series
Category	Inverter
Language	English