82 83
USING ADHESIVE MOUNTS
Follow these guidelines when attaching adhesive mounts to helmets,
vehicles and gear:
• Attach mounts at least 24 hours before you use them.
• Only attach the mounts to smooth surfaces. They won’t stick properly
to porous or textured surfaces.
• Firmly press mounts into place. Ensure the adhesive is in full contact
with the surface.
• Only use on clean, dry surfaces. Wax, oil, dirt or other debris will
weaken the bond and you could lose your camera.
• Attach mounts in room temperature conditions. They won’t stick
properly in cold or damp environments or on cold or damp surfaces.
• Check local and national regulations and laws to ensure that attaching
a camera to equipment (such as hunting gear) is permitted. Always
comply with regulations that restrict the use of consumer electronics
or cameras.
For more information about mounts, visit gopro.com.
Mounting Your GoPro
WARNING: The Curved Adhesive Mount and Mounting Buckle
included with MAX can be used for helmet mounting. Do not
use the Curved Fusion Mount (included with Fusion Mounts,
sold separately) to mount MAX to a helmet.
Always use a helmet that meets applicable safety standards if
you’re using a GoPro helmet mount or strap.
Choose the right helmet for your sport or activity, and make
sure that it’s the right size and t for you. Check to see
that your helmet’s in good condition and always follow the
manufacturer’s instructions on safe use.
Replace any helmet that’s been subjected to a major impact.
No helmet can protect against injury in every accident.
Be safe.
To avoid injury, do not use a tether when mounting the
camera on a helmet. Do not mount the camera directly on
skis or snowboards.
USING YOUR GOPRO AROUND WATER
MAX is waterproof to 5m. You won’t need an additional housing to
capture surf footage or any other shots on the water. MAX is not
designed for underwater use.
The touch screen may not work when wet, but you can use the Mode
button
to switch between Video, Photo and Time Lapse modes when
your camera is on.
PRO TIP: Use Screen Lock to prevent water from accidentally triggering
and changing settings on the touch screen.
1. Swipe down to access the Dashboard.
2. Tap
.
Mounting Your GoPro
To Next Page
Loading...
