8
860-7104-19 DTB Operation Manual
REASONABLY FORESEEABLE MISUSE
Do not operate above design capacities.
• Do not use the machine with more than two people on the
operator platform.
• Do not lift more than 250 kg maximum load on the operator
platform.
• Do not lift or convey more than 75 kg maximum distributed
load on the pivoting conveyor.
Conveying of unsuitable materials
• Do not convey wet materials
• Do not convey granular bulk materials
• Do not convey bags/sacks with loose material.
Non intended use of the machine
• Do not power other equipment from the Restu-it machine.
Use of modied module and tool systems
• Do not modify any parts of the machine.
Do not install spare parts or accessories not approved by the
manufacturer
Non-observance of signs of wear and damage
• Do not run belts if broken links are observed or there is visible
damage to the machine or debris causing damage to the
belts.
• Report and repair damaged operator buttons.
• Report and repair damaged electrical cables, cable track and
harnesses.
Service work by untrained or unauthorized personnel
• Do not open any panels without authorization.
Operating the machine although the operating instructions
are incomplete or not available in the local language
• Do not operate machine without reading the operating
instructions.
Operating the machine without the safety devices
provided
• Do not operate machine with missing or broken guards.
Deliberate or careless handling of the machine during
operation.
• Never reach over moving belts to clear product jams – stop
belts before clearing jams.
• Do not use E-Stops to stop belts or shut o machine – use
AC selector switch.
• Do not drive on sloped surfaces greater than 3% grade
maximum.
• Do not disconnect machine’s 16 pin electrical connector when
turned ON in AC mode.
• Keep hands away from any moving parts of the machine –
rollers, guards, cable track, etc.
• Only use ngers/hands to operate controls/switches.
• Do not introduce/push any objects into gaps of machine
components.
• Do not drive machine into trailer wall.
• Do not drive machine into trailers with obstructions, incorrect
alignment to dock.
• Do not transport people on moving belts.
• Do not reach over a moving belt.
• Do not run on or around the machine and conveyors.
• Do not adjust O-rings on transfer conveyors.
• Do not operate machine with persons on the machine base.
• Do not use machine in a wet environment.
• Do not drive machine on unstable surface, o the side of
dock plate or over holes.
• Do not raise/lower the operator platform or conveyor if they
are in contact with anything.
Maintenance work on an unsecured machine
Non-compliance with the operating instructions
• Do not drive or use the machine unless you have been
trained to operate it.
• Do not adjust any settings on battery chargers.
• Do not over rotate (zero turn) DTA machines to move the
machine sideways – reposition the machine slowly over a
distance of at least 15 ft using the forward/reverse functions.
• Do not park machine for more than 2 weeks without plugging
in charger.
• Keep hands and other body parts/ long hair o moving belts.
• Do not wear loose clothing while operating machine.
• Do not allow debris or sharp objects to accumulate on the
operator platform.
• Do not operate equipment if electrical connectors are
improperly secured or damaged.
• Do not drive machine over obstacles, debris on the oor.
• Adhere to all warning labels on the machines to avoid injury.
Non-compliance with maintenance instructions
• Do not adjust reroute cables on transfer conveyors unless
authorized.
• Only clean scanners with approved cleaning wipes.
• Do not use water or chemicals to clean the machine, unless
they are stipulated to be used for maintenance – see service
manual/bulletins.
Bypassing or changing the safety devices
• Do not rig or tape switches to keep them activated all the
time.
• Do not obstruct or damage beepers.
• Do not remove, cover up or alter any machine labels.
To Next Page
Loading...
