GMC-I Messtechnik GmbH 35
15 Repair and Replacement Parts Service
Calibration Center* and Rental Instrument Service
If required please contact:
GMC-I Service GmbH
Service Center
Thomas-Mann-Str. 20
90471 Nürnberg, Germany
Phone: +49 911 817718-0
Fax: +49 911 817718-253
e-mail: service@gossenmetrawatt.com
www.gmci-service.com
This address is only valid in Germany.
Please contact our representatives or subsidiaries for service in
other countries.
* Calibration laboratory for measured electrical quantities
DKD – K – 19701, accredited
in accordance wit DIN EN ISO/IEC 17025:2005
Accredited quantities: direct voltage, direct current value, direct current resistance,
alternating voltage, alternating current value, AC active power, AC apparent power,
DC power, capacitance, frequency, temperature
Competent Partner
GMC-I Messtechnik GmbH is certified in accordance with
DIN EN ISO 9001:2008.
Our DKD calibration laboratory is accredited by the Deutscher
Kalibrierdienst (German Calibration Service) under registration
number DKD–K–19701 in accordance with DIN EN ISO/
IEC 17025:2005.
We offer a complete range of expertise in the field of metrology:
from test reports and proprietary calibration certificates right on up to
DKD calibration certificates.
Our spectrum of offerings is rounded out with free test equipment
management.
An on-site DKD calibration station is an integral part of our service
department. If errors are discovered during calibration, our spe-
cialized personnel are capable of completing repairs using original
replacement parts.
As a full service calibration laboratory, we can calibrate instru-
ments from other manufacturers as well.
16 Product Support
If required please contact:
GMC-I Messtechnik GmbH
Product Support Hotline
Phone: +49 911 8602-0
Fax: +49 911 8602-709
e-mail support@gossenmetrawatt.com
To Next Page
Loading...
